This topic contains 0 replies, has 1 voice, and was last updated by 
Viewing 1 post (of 1 total)
-
Posts
-
Problem: Transmitter failed during enable sequence
Front Panel indication status: Cut back Led Red, Power Amp Led Red, and Battery Led also Red.
Procedure adopted: The voltage of Battery checked using multimeter no voltage found. So fault was due to battery.
Action: Batteries replaced but still fault indications now again pushed the reset button on front panel. So all Red inductions cleared.
Fault Removed and transmitter Enabled successfully.
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.